Panasonic PT-RZ670

Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 99
3) Press as to select [EDID MODE].
4) Press the <ENTER> button.
f The [DIGITAL LINK EDID MODE] screen is displayed.
5) Press qw to switch [EDID MODE].
f The items will switch each time you press the button.
[DEFAULT] Standard setting.
[SCREEN FIT] Changes data of EDID according to the setting of [SCREEN FORMAT].
[USER] Sets [RESOLUTION] or [VERTICAL SCAN FREQUENCY] item to EDID.
f When [DEFAULT] or [SCREEN FIT] is selected, proceed to Step 10).
6) Press the <ENTER> button.
f The [RESOLUTION] screen is displayed.
7) Press asqw to select [RESOLUTION].
f Select [1024x768p], [1280x720p], [1280x768p], [1280x800p], [1280x1024p], [1366x768p], [1400x1050p], [1440x900p], [1600x900p],
[1600x1200p], [1680x1050p], [1920x1080p], [1920x1080i], or [1920x1200p].
8) Press the <ENTER> button.
f The [VERTICAL SCAN FREQUENCY] screen is displayed.
9) Press qw to select [VERTICAL SCAN FREQUENCY].
f Select [60Hz], [50Hz], [48Hz], [30Hz], [25Hz], or [24Hz].
f [48Hz] can be selected only when [1920x1080i] is selected for [RESOLUTION].
f [30Hz], [25Hz], or [24Hz] can be selected only when [1920x1080p] is selected for [RESOLUTION].
10) Press the <ENTER> button.
f The conrmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f The setting details are displayed in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] of [EDID STATUS].
f The resolution and vertical scanning frequency settings may be required on your computer or video device.
f After conguring settings, your computer or video device or the projector may be required to be restarted.
f Output with resolution and vertical scanning frequency that have been set may not be performed depending on your computer or video
device.
[SDI IN]
(Only for PT-RZ670)
Set this item according to the signal to be input to the <SDI IN> terminal.
Setting [SIGNAL LEVEL]
Select the amplitude of the signal to input.
1) Press as to select [SDI IN].
2) Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3) Press as to select [SIGNAL LEVEL].
4) Press qw to switch the item.
[64-940] Normally use this setting.
[4-1019] Select when gray is displayed as black.
Setting [BIT DEPTH]
1) Press as to select [SDI IN].
2) Press the <ENTER> button.
f The [SDI IN] screen is displayed.