Panasonic PT-RZ670

Chapter 2 Getting Started — Setting up
30 - ENGLISH
Setting up
Installation mode
There are six ways to set up the projector. Set the [PROJECTOR SETUP] menu → [PROJECTION METHOD] (x page 107) depending on
the installation mode. Set [COOLING CONDITION] to [AUTO]. Using the projector with [COOLING CONDITION] set incorrectly may shorten
the life of the light source.
Mounting on the ceiling and projecting forward Setting on a desk/oor and projecting from rear
(Using the translucent screen)
Menu item Method Menu item Method
[PROJECTION METHOD] [FRONT/CEILING] [PROJECTION METHOD] [REAR/FLOOR]
[COOLING CONDITION] [AUTO] [COOLING CONDITION] [AUTO]
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Setting on a desk/oor and projecting forward
Menu item Method Menu item Method
[PROJECTION METHOD] [REAR/CEILING] [PROJECTION METHOD] [FRONT/FLOOR]
[COOLING CONDITION] [AUTO] [COOLING CONDITION] [AUTO]
Portrait setting and projecting from the rear
(Using the translucent screen)
Portrait setting and projecting forward
Menu item Method Menu item Method
[PROJECTION METHOD] [REAR/FLOOR] [PROJECTION METHOD] [FRONT/FLOOR]
[COOLING CONDITION] [AUTO] [COOLING CONDITION] [AUTO]
Note
f In the portrait setting, the on-screen menu is displayed sideways.
To display the menu vertically, change the setting of the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [OSD ROTATION]
(x page 100).