Panasonic PT-RZ670

Chapter 4 Settings — [DISPLAY OPTION] menu
94 - ENGLISH
4) Press qw to switch the item.
[ON] Adjust the screen position and size when automatic setup is executed.
[OFF] Does not perform automatic adjustment.
Adjusting signal level automatically
1) Press as to select [AUTO SETUP].
2) Press the <ENTER> button.
f The [AUTO SETUP] screen is displayed.
3) Press as to select [SIGNAL LEVEL ADJUST].
4) Press qw to switch the item.
[OFF] Does not perform automatic adjustment.
[ON]
Adjusts black level (on-screen menu [BRIGHTNESS]) and white level (on-screen menu
[CONTRAST]) when automatic setup is executed.
Note
f [SIGNAL LEVEL ADJUST] may not function properly unless a still image containing clear blacks and whites is input.
[BACKUP INPUT SETTING]
Set the backup function to switch the signal to the backup input as seamless as possible when input signal is disrupted.
1) Press as to select [BACKUP INPUT SETTING].
2) Press the <ENTER> button.
f The [BACKUP INPUT SETTING] screen is displayed.
3) Press as to select [BACKUP INPUT MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Disables the backup function.
[ON]
Enables the backup function to switch the input signal as seamless as possible when the same signal
is input to the primary and secondary inputs.
5) Press as to select [AUTOMATIC SWITCHING].
f When [BACKUP INPUT MODE] is set to [OFF], [AUTOMATIC SWITCHING] cannot be selected.
6) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE] Disables the automatic input switching function.
[ENABLE] Switches to the secondary input automatically when the input signal for primary input is disrupted.
Note
f Primary input is xed to the <DVI-D IN> terminal, and the secondary input is xed to the <HDMI IN> terminal.
f Backup function is enabled only when the same signal is input to the <DVI-D IN> and <HDMI IN> terminals.
f When [BACKUP INPUT MODE] is [ON], [BACKUP INPUT STATUS] is displayed in the input guide.
[BACKUP INPUT STATUS] shows whether switching to the backup input signal is possible or not.
f If the input of DVI-D and HDMI are switched when switching to the backup input signal is possible, the input is switched seamlessly.
However, depending on your computer or video equipment, the input may not be switched seamlessly.
f [BACKUP INPUT SETTING] cannot be set during P IN P. The backup operation is not performed either.
[RGB IN]
Set to match the signal to input to the <RGB 1 IN> terminal.
Setting [RGB1 INPUT SETTING]
1) Press as to select [RGB IN].