Panasonic PT-RZ670

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 109
Setting [OPERATING MODE]
1) Press as to select [OPERATION SETTING].
2) Press the <ENTER> button.
f The [OPERATION SETTING] screen is displayed.
3) Press as to select [OPERATING MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL] Set this item when high luminance is required. The estimated runtime is approximately 20 000 hours.
[ECO]
Although the luminance is lower than that of [NORMAL], set this item to increase the life of the light
source. The estimated runtime is approximately 24 000 hours.
[LONG LIFE1]
Although the luminance is lower than that of [ECO], set this item to increase the life of the light
source. The estimated runtime is approximately 43 000 hours.
[LONG LIFE2]
Although the luminance is lower than that of [LONG LIFE1], set this item to increase the life of the
light source. The estimated runtime is approximately 61 000 hours.
[LONG LIFE3]
Although the luminance is lower than that of [LONG LIFE2], set this item to increase the life of the
light source. The estimated runtime is approximately 87 000 hours.
[USER1]
Set [MAX LIGHT OUTPUT LEVEL] and [LIGHT OUTPUT] individually.[USER2]
[USER3]
5) Press as to select [APPLY].
6) Press the <ENTER> button.
7) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f When [OPERATING MODE] setting is [---], changes to [OPERATING MODE] are restricted. Consult your dealer.
f The [OPERATING MODE] settings are not reset to the factory defaults even when [ALL USER DATA] is executed from the [PROJECTOR
SETUP] menu → [INITIALIZE] (x page 124).
f When the [PROJECTOR SETUP] menu → [HIGH ALTITUDE MODE] is set to [OVER 2700m], the items of [ECO], [LONG LIFE1], [LONG
LIFE2], and [LONG LIFE3] cannot be selected.
Setting [MAX LIGHT OUTPUT LEVEL]
Adjusts the maximum level to correct screen brightness according to the changes in brightness of the light source.
1) Press as to select [OPERATION SETTING].
2) Press the <ENTER> button.
f The [OPERATION SETTING] screen is displayed.
3) Press as to select [MAX LIGHT OUTPUT LEVEL].
4) Press qw to adjust.
Operation Adjustment Range of adjustment
Press w.
Increases the maximum level of brightness correction.
10.0 % - 100.0 %
Press q.
Decreases the maximum level of brightness correction.
5) Press as to select [APPLY].
6) Press the <ENTER> button.
7) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f When [OPERATING MODE] is set to [NORMAL], [ECO], [LONG LIFE1], [LONG LIFE2], or [LONG LIFE3], the item of [MAX LIGHT OUTPUT
LEVEL] cannot be adjusted.
f When the [PROJECTOR SETUP] menu → [BRIGHTNESS CONTROL] → [BRIGHTNESS CONTROL SETUP] → [CONSTANT MODE] is
set to [AUTO] or [PC], that setting is applied for brightness correction.