Panasonic PT-TMZ400

Connecting
terminals
<HDMI IN 1> terminal
<HDMI IN 2> terminal
HDMI x 2, HDCP compatible, Deep Color compatible
Audio signal Linear PCM (sampling frequency: 48 kHz/44.1 kHz/32 kHz)
<LAN> terminal RJ-45 x 1, for network connection, PJLink (class 2) compatible, 10Base-T/100Base-TX
<COMPUTER 1 IN>
terminal
High-density D-Sub 15 p (female) x 1
RGB signal
0.7 V [p-p] 75 Ω (SYNC ON GREEN: 1.0 V [p-p] 75 Ω)
SYNC/HD
TTL high impedance, automatic positive/negative polarity
compatible
VD
TTL high impedance, automatic positive/negative polarity
compatible
YP
B
P
R
signal Y: 1.0 V [p-p] including synchronization signal, P
B
P
R
: 0.7 V [p-p] 75 Ω
<COMPUTER 2 IN>
terminal
High-density D-Sub 15 p (female) x 1
RGB signal
0.7 V [p-p] 75 Ω (SYNC ON GREEN: 1.0 V [p-p] 75 Ω)
SYNC/HD
TTL high impedance, automatic positive/negative polarity
compatible
VD
TTL high impedance, automatic positive/negative polarity
compatible
YP
B
P
R
signal Y: 1.0 V [p-p] including synchronization signal, P
B
P
R
: 0.7 V [p-p] 75 Ω
<AUDIO IN 1> terminal
<AUDIO IN 2> terminal
M3 stereo mini jack x 2, 0.5 V [rms], input impedance 22 kΩ or more
<AUDIO OUT> terminal
M3 stereo mini jack x 1, monitor output and stereo compatible, 0 V [rms] to 2.0 V [rms]
(variable), output impedance 2.2 kΩ or lower
<USB (VIEWER/
WIRELESS/DC OUT)>
terminal
USB connector (type A) x 1, for Memory Viewer function/ Wireless module (Model No.:
AJ-WM50) connection/power supply (DC 5 V, maximum 2 A)
<SERIAL IN> terminal D-Sub 9 p x 1, RS-232C compliant, for computer control
Acoustic noise
*1
35 dB When [LIGHT POWER] in [ECO MANAGEMENT] is set to [NORMAL] or [ECO].
24 dB When [LIGHT POWER] in [ECO MANAGEMENT] is set to [QUIET]
Operating
environment
Operating temperature 0 °C (32 °F) to 45 °C (113 °F)
*2*3
Operating humidity 20 % to 80 % (no condensation)
Operation position [FRONT/CEILING], [FRONT/DESK], [REAR/CEILING], [REAR/DESK]
Power requirements
110 V ~ (110 V alternating current), 60 Hz (for Taiwan)
100 V - 240 V ~ (100 V - 240 V alternating current), 50 Hz/60 Hz (for other countries and
regions)
Rated current
PT-TMZ400
2.3 A (for Taiwan)
2.6 A - 1.0 A (for other countries and regions)
PT-TMW380, PT-TMX380
2.2 A (for Taiwan)
2.5 A - 1.0 A (for other countries and regions)
Maximum power consumption
PT-TMZ400 240 W (The power consumption is 230 W at 200 V - 240 V.)
PT-TMW380, PT-TMX380 230 W (The power consumption is 220 W at 200 V - 240 V.)
*1 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118:2020 international standards.
*2 The projector cannot be used at an altitude of 2 700 m (8 858') or higher above sea level.
If the operating environment temperature exceeds the following value, the light output may be reduced to protect the projector.
f When using the projector at an altitude lower than 700 m (2 297') above sea level: 36 °C (97 °F)
f When using the projector at an altitude between 700 m (2 297') and 1 400 m (4 593') above sea level: 34 °C (93 °F)
f When using the projector at an altitude between 1 400 m (4 593') and 2 100 m (6 890') above sea level: 32 °C (90 °F)
f When using the projector at an altitude between 2 100 m (6 890') and 2 700 m (8 858') above sea level: 30 °C (86 °F)
*3 The projector’s operating environment temperature should be within 0 °C (32 °F) to 40 °C (104 °F) when the optional wireless module
(Model No.: AJ-WM50) is attached.
ENGLISH - 153
Chapter 7 Appendix - Specications