Caution label at the back of the remote control
Note
f The remote control can be used within a distance of about 20 m (65'7") if pointed directly at the remote control signal receiver. The remote
control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate correctly.
f You can operate the projector by reecting the remote control signal on the screen. The operating range may differ due to the loss of light
caused by the properties of the screen.
f When the remote control signal receiver is lit with a uorescent light or other strong light source, the projector may become inoperative. Set
the projector as far from the luminous source as possible.
f The power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.
Projector body
6
6
7
1481312111098
1
2
3
4 5
17
15 16
18
r Front
r Side
r Rear
r Top
r Bottom
: Projection direction
ENGLISH - 27
Chapter 1 Preparation - About your projector
To Next Page
Loading...
