How to adjust the state of the image
If the projected image or the position is not correct when the positioning of the projector and the screen is correctly
installed, adjust the projection angle and focus.
Focus ring
1) Adjust the projection angle.
f Place the projector on a level surface and make its front side parallel to the screen surface so that the
projection screen is rectangular.
f If the screen is tilted downward, extend the adjustable feet and adjust the projection screen so that the
projected screen is rectangular.
For details, see “Adjusting adjustable feet” (x page 51).
2) Adjust the focus.
f Rotate the focus ring to adjust the focus of the projected image.
Note
f It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
f If you adjust the focus, you may need to adjust the size of the image by changing the distance between the screen and the projector.
f When the focus is adjusted, the projection screen size also changes slightly. Depending on the image projection situation, repeat Steps 1) to
2) to adjust to the best projection condition.
f Adjust from the [POSITION] menu → [SCREEN ADJUSTMENT] when the projected image is distorted.
Adjusting adjustable feet
Install the projector on a at surface so that the front of the projector is parallel to the screen surface and the
projection screen is rectangular.
If the screen is tilted downward, extend the adjustable feet so that the projected image becomes rectangular.
The adjustable feet can be extended by turning it as shown in the gure. Turning the adjustable feet in the
opposite direction will return it to the original position.
Maximum adjustable range
Adjustable feet: 30 mm (1-3/16") each
Attention
f Be careful not to block the intake/exhaust vents with your hands or any objects when adjusting the adjustable feet while the light source is
on. (x page 27)
ENGLISH - 51
Chapter 3 Basic Operations - Projecting
To Next Page
Loading...
