Note
f If NETWORK input is selected, the image from a computer (including iPad / iPhone / iPod touch and Android device) can be transferred via
wireless LAN/wired LAN to the projector by using the Panasonic image transfer application software.
For details about the image transfer application software “Presenter Light” and “Wireless Projector”, refer to the website (https://panasonic.
net/cns/projector/).
f If one of COMPUTER 1 / COMPUTER 2 / HDMI 1 / HDMI 2 input is selected and no signal is input, the following screen is displayed. Check
the output setting of your computer.
Switching the input with the control panel
The input can be switched with the <INPUT SELECT> button on the control panel
After pressing the <INPUT SELECT> button, the detailed or simple input guide is displayed.
Detailed input guide example Simple input guide example
1) Press the <INPUT SELECT> button on the control panel.
f The input guide is displayed.
2) Press the <INPUT SELECT> button again.
f The input is switched every time you press the <INPUT SELECT> button.
f When the detailed input guide is displayed, you can select the input with the asqw buttons on the control
panel or on the remote control.
Note
f You can switch the detailed/simple input guide by setting the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [INPUT GUIDE].
f When the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [INPUT GUIDE] is set to [OFF], the input guide is not displayed.
50 - ENGLISH
Chapter 3 Basic Operations - Projecting
To Next Page
Loading...
