f The test pattern will switch each time you press the button.
All white
The test pattern is displayed together with the operation guide of [PATTERN SELECT]. Select your
desired test pattern.
Color bar (Vertical)
Color bar (Horizontal)
Cross
Cross (Inversion)
Cross hatch
Note
f If [TEST PATTERN] is assigned to the <FUNCTION> button on the remote control, the all white pattern will be displayed after pressing the
<FUNCTION> button.
[FILTER COUNTER]
This function is used to check the usage time of the air lter or set the cleaning/replacement cycle of the air lter.
Also, you can reset the air lter usage time.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
[FILTER COUNTER]
Displays the usage time of the air lter.
[TIMER]
Sets the cleaning/replacement cycle of the air lter.
[FILTER COUNTER RESET]
Resets the air lter usage time.
Setting [TIMER]
If you want to regularly clean/replace the air lter, set its cycle time. When the air lter usage time reaches the set
time, a message of “FILTER COUNTER has reached the set time” prompting you to clean/replace the air lter is
displayed on the projection screen.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
3) Press as to select [TIMER].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Select not to display the message.
[1000H] - [20000H] Select to display the message. You can set the cleaning/replacement cycle of the air lter.
Setting [FILTER COUNTER RESET]
Resets the usage time of the air lter.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
3) Press as to select [FILTER COUNTER RESET].
4) Press the <ENTER> button.
5) When the confirmation screen is displayed, press qw to select [OK] and then press the <ENTER>
button.
f The display of [FILTER COUNTER] changes to “0H”.
[HDMI CEC]
Sets the CEC (Consumer Electronics Control) function of HDMI.
CEC is a function that is realized by exchanging device control signals with external devices connected with
an HDMI cable. Using the remote control of the projector, it is possible to operate the CEC-compatible external
90 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
