Note
f If the CEC-compatible device does not support CEC 1.4, it may not support the link control described in the manual.
f Depending on the connected CEC-compatible device, the link control may not operate normally.
[INITIALIZE ALL]
Return various setting values to their factory default settings.
1) Press as to select [INITIALIZE ALL].
2) Press the <ENTER> button.
3) When the [INITIALIZE ALL] screen is displayed, press qw to select [OK] and then press the <ENTER>
button.
4) When the power off confirmation screen is displayed after a while, press the <ENTER> button.
f The operations except for powering off are disabled.
Note
f When the [SECURITY] menu → [PASSWORD] is set to [ON], the [PASSWORD] screen will be displayed after selecting [INITIALIZE ALL]
and pressing the <ENTER> button. Enter the security password set for the projector and continue your desired operation.
f The projector will enter the standby status to reect the setting values when [INITIALIZE ALL] is executed.
f Even if [INITIALIZE ALL] is performed, the settings of the following items cannot be initialized.
g [STANDBY MODE]
g [RS-232C] → [EMULATE] / [BAUDRATE]
g [FILTER COUNTER]
g [NETWORK]
f To initialize the settings of [NETWORK], perform the [NETWORK] menu → [INITIALIZE].
f When [INITIALIZE ALL] is executed, the [INITIAL SETTING] screen is displayed when the projection starts next time.
ENGLISH - 93
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
