Setting the link control
Make settings for the link control between the projector and CEC-compatible devices.
[PROJECTOR -> DEVICE]
Set the link control from the projector to the CEC-compatible device.
1) Press as to select [HDMI CEC].
2) Press qw to select [ON].
3) Press the <ENTER> button.
f The [HDMI CEC] screen is displayed.
4) Press as to select [PROJECTOR
->
DEVICE].
5) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
Disables the power link control from the projector to the CEC-compatible device.
Select this when you do not want the power status of the CEC-compatible device to link with the power status
of the projector.
[POWER OFF]
Enables power-off link control.
When you turn off the power of the projector and put it in standby mode, all CEC-compatible devices
connected to the <HDMI IN 1> terminal or <HDMI IN 2> terminal will enter standby mode.
Power-on link control is disabled.
[POWER ON/OFF]
Enables power-on link control and power-off link control.
If you turn on the projector and start projection, the CEC-compatible device connected to the <HDMI IN 1>
terminal or <HDMI IN 2> terminal will turn on.
When you turn off the projector and put it in standby mode, all CEC-compatible devices connected to the
<HDMI IN 1> terminal or <HDMI IN 2> terminal will enter standby mode.
[DEVICE -> PROJECTOR]
Set the link control from the CEC-compatible device to the projector.
1) Press as to select [HDMI CEC].
2) Press qw to select [ON].
3) Press the <ENTER> button.
f The [HDMI CEC] screen is displayed.
4) Press as to select [DEVICE
->
PROJECTOR].
5) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
Disables the power link control from the CEC-compatible device to the projector.
Select this when you do not want the power status of the projector to link with the power status of the CEC-
compatible device.
[POWER ON]
Enables power-on link control.
While the projector is in standby, if the CEC-compatible device connected to the <HDMI IN 1> terminal or
<HDMI IN 2> terminal is turned on or starts playing, the projector turns on, starts projection, and switches
to the input that the linked CEC-compatible device is connected. While the projector is turned on, if the
CEC-compatible device starts playing, the projector switches to the input that the CEC-compatible device is
connected.
Power-off link control is disabled.
[POWER ON/OFF]
Enables power-on link control and power-off link control.
While the projector is in standby, if the CEC-compatible device connected to the <HDMI IN 1> terminal or
<HDMI IN 2> terminal is turned on or starts playing, the projector turns on, starts projection, and switches
to the input that the linked CEC-compatible device is connected. While the projector is turned on, if the
CEC-compatible device starts playing, the projector switches to the input that the CEC-compatible device is
connected.
When the CEC-compatible device connected to the <HDMI IN 1> terminal or <HDMI IN 2> terminal is turned
off, the projector enters standby mode.
92 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
