[6POINT CORRECTION]
[UPPER MIDDLE] [LOWER MIDDLE]
Note
f Pressing the <ENTER> button while the individual adjustment screen is displayed can switch to the individual adjustment screen of other
items.
[SHIFT]
(Only for COMPUTER1 / COMPUTER2 input)
Move the image position vertically or horizontally if the image position projected on the screen is shifted even
when the relative position of the projector and the screen is installed correctly.
1) Press as to select [SHIFT].
2) Press the <ENTER> button.
f The [SHIFT] screen is displayed.
3) Press asqw to adjust the position.
Orientation Operation Adjustment
Vertical (up and down)
adjustment.
Press the a button.
The image position moves up.
Press the s button.
The image position moves down.
Horizontal (right and left)
adjustment.
Press the w button.
The image position moves to the right.
Press the q button.
The image position moves to the left.
Note
f Depending on the input signal, if the adjustment of [SHIFT] exceeds the effective adjustment range of the input signal, the position of the
image cannot be changed. Adjust within the effective adjustment range.
[DOT CLOCK]
(Only for COMPUTER1 input / COMPUTER2 input)
Adjust to reduce noise generated when projecting vertical stripes.
When projecting a striped pattern, periodic stripes (noise) may occur. In this case, adjust so that the noise is the
least.
1) Press as to select [DOT CLOCK].
ENGLISH - 73
Chapter 4 Settings - [POSITION] menu
To Next Page
Loading...
