1 Projection Lens
2 Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power.
3 Light source indicator <LIGHT>
Indicates the status of the light source.
4 Temperature indicator <TEMP>
Indicates the internal temperature status.
5 Remote control signal receiver (front)
6 Adjustable feet
Adjusts the projection angle.
7 Exhaust vent
8 Intake vent
9 Connecting terminals (x page 29)
10 Remote control signal receiver (rear)
11 Security slot
This security slot is compatible with the Kensington security
cables.
Connects the supplied power cord.
13 Speaker
14 Air lter cover
The air lter unit is inside.
15 Focus ring
Adjusts the focus.
16 Ambient luminance sensor
17 Control panel (x page 28)
18 Burglar hook port
Attaches a burglar prevention cable, etc.
Attention
f Do not block the intake and exhaust vents of the projector.
The components may deteriorate faster if cooling inside the projector is inhibited.
r Control panel
6
5
2
7
8
1
3
4
2
1 Power <v/b> button
(v: Standby, b: Power on)
Sets the projector to the state where the projector is switched
off (standby mode). Also starts projection when the power is
switched off (standby mode).
2 <VOL
-
> button / <VOL+> button
Adjusts the volume of the built-in speaker or audio output.
(x page 52)
3 <MENU> button
Displays or hides the main menu. (x page 59)
When the sub menu is displayed, pressing it will return to the
previous screen.
4 <ENTER> button
Determines and executes an item in the menu screen.
5 <SHUTTER> button
Used to turn off the audio and video temporarily. (x page 52)
6 <INPUT SELECT> button
Switches the input signal to project. (x page 49)
Used to automatically adjust with auto setup function while
projecting the image (x page 53).
8 asqw buttons
Used to select the menu screen items, switch the setting or
adjust the level.
Also used to enter a password in the [SECURITY] menu or enter
characters.
28 - ENGLISH
Chapter 1 Preparation - About your projector
To Next Page
Loading...
