Panasonic SC-HM910 - Pinch Roller and Head Block Replacement

SC-HM910/SC-HM810
25
1. Locate the name plate of motor to the traverse ass’y.
2. Align the hole of motor with the ribs.
7.8. Replacement for the pinch roller ass’y and head block
• Follow the (Step 1) - (Step 2) of item 7.1.
• Follow the Disassembly for the CD Changer of item 7.2.
• Follow the (Step 1) - (Step 14) of item 7.4.
Step 1 Remove the connector.??
Step 2 Remove 3 screws.
Step 3 Remove the 2 claws, and then draw the front panel
ass’y.
Step 4 Pull out the FFC.
Step 5 Remove the flat cable from the connector.
Step 6 Push the lever upward, and then open the cassette lid
ass’y (For DECK1 and DECK2).
Step 7 Remove the flat cable from the connector (CN1001).
Step 8 Remove the 5 screw.
Step 9 Tilt the cassette mechanism in the direction of arrow
(1), and then remove it in the direction of arrow (2).
Step 10 Unsolder the motor
terminals.
Claw
a x 3
(step 2)
Claw
(Step 4)
(Step 7)
(Step 5)
Cassette
lid
ass’y
(Step 7)
(Step 8)
a x 5
Cassette mechanism
(Step 10)
a x 3
(step 11)
(2)
(1)