Panasonic SC-HM910 - Schematic Diagram

SC-HM910/SC-HM810
38
13 Schematic Diagram
(All schematic diagrams may be modified at any time with the
development of the new technology)
Note:
SW1 : Push switch
SW2 : Push switch
SW3 : Switch
SW4 : Cd switch
SW5 : Lock switch
S904 : Power switch
S602 : Preset EQ switch
S603 : Deck 1/2 switch
S604 : Rec switch
S605 : CD open/close switch
S606 : CD 1 switch
S607 : CD 2 switch
S608 : CD 3 switch
S609 : CD 4 switch
S610 : CD 5 switch
S612 : S.SEQ switch
S613 : S.WOOFER switch
S614 : UP/Album switch
S615 : Right cursor switch
S616 : Down switch
S617 : Left cursos switch
S618 : Title search switch
S619 : Enter switch
S620 : Marker switch
S621 : Delete switch
S701 : Reset switch
S901 : Rew switch
S902 : Tuner switch
S903 : CD play switch
S904 : FF switch
S905 : Stop switch
S906 : Deck 2 open switch
S907 : Tape switch
S908 : Aux switch
S909 : Deck 1 open switch
S910 : Display switch
S911 : Explosion switch
S912 : Applauses switch
S913 : Rhythm 1 switch
S914 : Rhythm 2 switch
S951 : Mode switch
S952 : Half switch
S971 : Mode switch
S972 : Half switch
S975 : Recinh-f switch
VR900 : Volume jog
VR930 : Mic volume jog
• The voltage value and waveforms are the reference voltage
of this unit measured by DC electronic voltmeter (high imped-
ance) and oscilloscope on the basis of chassis.
Accordingly, there may arise some error in voltage values and
waveforms depending upon the internal impedance of the tester
of the measuring unit.