Panasonic TH-42LF6W - Picture Position and Size Adjustment; Manual and Auto Adjustment

27
Adjusting Pos. /Size
Press to select the menu to adjust.
Press to adjust the menu.

0
Normal
Normalise
Auto Setup
Pos. /Size
V-Pos
0
H-Pos
V-Size
Clock Phase
H-Size
1:1 Pixel Mode
Dot Clock
0
0
0
0
Off
Note:
Unadjustable items are
grayed out.
Adjustable items differ
depending on the input signal
and the display mode.
1
Press to display the Pos. /Size menu.
2
3
4
Note:
 If a “Cue” or “Rew” signal from a VCR or DVD player is received, the picture position will shift up or down. This
picture position movement cannot be controlled by the Pos. /Size function.
Auto Setup H-Pos/V-Pos, H-Size/V-Size, Dot Clock and Clock Phase are automatically adjusted when the RGB or
PC signal is received.
This setting only operates when a PC signal or RGB signal is input, and the aspect is “16:9”.
Using Remote Control
When 
When Auto Setup does not work, “Invalid” is displayed.
Notes:
 Auto Setup may not work when a cropped or dark image is input. In such case, switch to a bright
image with borders and other objects are clearly shown, and then try auto setup again.
 
position/size as required.
 If Auto Setup cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz and
1366×768@60Hz), pre-selecting the individual signal in “XGA Mode” (see page 44) may results
in correct Auto Setup.
 Auto Setup does not work well when a signal such as additional information is superimposed out of
valid image period or intervals between synchronizing and image signals are short.
 If Auto Setup cannot adjust correctly, select “Normalise” once and press ACTION (
) then adjust
Pos. /Size manually.
 If the picture goes off screen in the horizontal direction as a result of performing Auto Setup, perform
Dot Clock adjustment.