10-12 12
4) Click on "Adjust the Scanned Image Quality" on the bottom left corner of the above picture,
the advanced properties interface will pop up, then users can set the scan; After nishing the
settings, click on the "OK" button, then "Scan" button to start scan.
2.Photoshop
Operation Steps:
1) Launch Photoshop, click "File"- "Import" on the top left conrner and select WIA Scan, as is
shown below:
2) After the window pops up, please refer to Step 3 and Step 4 of 10.2.3.1. to see the specic
operation steps.
To Next Page
Loading...
