25 Programming Guide
Other Settings and Modes
Partition Programming
Section Description
[950] Reset all programmable sections to factory default values
[955] Clear bus module trouble (remove disconnected module from the bus)
[960] Remote control serial number display (press any button on the assigned remote, then press [ENTER] to view the next digit)
[970] Download memory key into panel (see the Reference & Installation Manual)
[975] Upload panel into the memory key (see the Reference & Installation Manual)
[980] Display version number of the panel (press [ENTER] to view the next digit)
[741] Partition 1 Options
Option OFF ON
[1] Auto-arm on time
N Disabled N Enabled
[2] Auto-arm on no movement
N Disabled N Enabled
[3]& [4]
Auto-arm arming mode
N See Table N See Table
[5] Switch to stay arming if no zone entry delay is opened
N Disabled N Enabled
[6] Follow zones become entry delay 2 when delay zone is bypassed
N Disabled N Enabled
[7]& [8] N/A N/A N/A
[742] Partition 2 Options
Option OFF ON
[1] Auto-arm on time
N Disabled N Enabled
[2] Auto-arm on no movement
N Disabled N Enabled
[3]& [4]
Auto-arm arming mode
N See Table N See Table
[5] Switch to stay arming if no entry delay is opened
N Disabled N Enabled
[6] Follow zones become entry delay 2 when delay zone is bypassed
N Disabled N Enabled
[7]& [8] N/A N/A N/A
[3] [4]
OFF OFF Regular
OFF ON Sleep
ON OFF Stay
[3] [4]
OFF OFF Regular
OFF ON Sleep
ON OFF Stay
To Next Page
Loading...
