Parker EX Series - Page 108

108 – Pvd3665_Gb_Ex_August 2022
Step 4 – Fitting of the rear cover :
1. Slowly take up any slack in the cables and close the cover Ref 3.
2. Tighten the cable gland caps Ref 2 at the torque value of :
Cable gland size
Torque (N.m)
M16
12,5
M20
20
3. Tighten the screws of the connection modules Ref 6 at the torque value of 0,5
N.m.
4. Place the rear cover Ref 3 and take care to don’t cut the toric seal placed on the
rear flange.
5. Tighten the 4 nuts Ref 1 at the torque value of 5,6 N.m.
6. Connect the outside ground with the screw Ref 7 and tighten it at the torque value
of 2,5 N.m.