ANAFI
28
Precise Landing, Android
SMART LIPO BATTERY
ANAFI’s smart LiPo battery is preinstalled on the drone and should always be reinstalled in
the same way, with the LEDs and power button facing up, to avoid irrecoverable electric
damage to the battery, to the drone, or to both.
The smart battery can be charged whether it is installed on ANAFI, or not. However, you
will need to remove the battery from the drone to access your microSD card. Refer to the
“Retrieving media” section of this guide for further information.
When handling ANAFI, you should never apply pressure and generally avoid
touching the drone’s camera and gimbal – its most sensitive parts. The following
directions will help you handle your drone and battery safely.
Battery removal
To remove the smart battery from the drone, unfold the back arms of ANAFI. Set the
drone on a flat and even surface (such as a table), and press the push-button which
connects the battery to the body of the drone with your thumb. Gently slide your
thumb and the battery toward the back of ANAFI. When the hook of the push-button
is disengaged from the body of the drone, lift the battery away from ANAFI.
ANAFI: battery removal
To Next Page
Loading...
Need help?
General
