ANAFI
User Guide v2.6 – published on August 30, 2019
31
Like all other LiPo batteries, ANAFI’s smart battery must be handled, transported and stored
with care:
- never leave a battery unattended while charging;
- never expose a battery to extreme temperatures, neither hot, nor cold;
- never charge a battery which is still warm from use (wait for at least 20 minutes);
- never use or recharge a damaged or swollen battery;
- always store your battery in a dry, ventilated place, at a temperature close to 20°C;
- always carry your battery in a fire-retardant bag or case (unless it is installed on
ANAFI: it can then be transported with the drone, inside its carrying case).
Finally, note that ANAFI’s smart battery will only allow charge in ambient temperatures
between +10°C and +45°C, and that using ANAFI in temperatures approaching 0°C will
reduce its flying time. To minimize this slight drop in the smart battery’s capacity, keep your
battery as warm as possible before starting a flight in a cold environment.
If the behavior of your battery is not consistent with the elements contained in this
section, and if you cannot get it to power your ANAFI, you must hard reset your
battery: plug it to a power source with the enclosed cable, then keep the battery’s
power button pressed for 15 seconds (regardless of the behavior of the LEDs), and
release the button.
The battery’s LEDs flash quickly, one after the other, alternating green and red: the
hard reset is successful!
MEDIA RETRIEVAL
Your ANAFI is equipped with a 16GB microSD card which enables you to record videos and
photos, and to transfer them easily to your computer. This section explains how to extract
the microSD card from ANAFI, how to retrieve your media from the microSD card, and how
to reinstall it in the drone.
Extracting the microSD card
To extract the microSD card from ANAFI, the battery must be removed from the
drone. Refer to the “Battery removal” section of this guide for details.
When you remove the battery from the body of the drone, you uncover the microSD
slot, which is protected by a small metal lock.
Slide this metal lock with a finger toward the back of ANAFI to open it – you will feel
a slight click. Lift the front part of the lock to open the slot. Reach the microSD card
and extract it. An open lock icon and an arrow, located on the left of the microSD
slot, confirm to you the way you must slide the lock to open it.
Retrieving photos and videos
Use the enclosed microSD to SD card adapter to transfer videos and photos you
have taken with ANAFI to your computer. Slide the microSD card into the adapter
To Next Page
Loading...
Need help?
General
