ANAFI
User Guide v2.6 – published on August 30, 2019
29
Battery installation
To install the smart battery back on the drone, unfold the back arms of ANAFI. Set
the drone on a flat and even surface (such as a table), and position the battery’s
three hooks into the drone’s corresponding slots. Place your middle finger on the
Parrot logo of ANAFI and your thumb on the back of the smart battery. Squeeze your
fingers together until you feel and hear the battery clicking into the body of the
drone. You are set!
ANAFI: battery installation
Battery charging
To charge ANAFI’s smart LiPo battery, use the enclosed USB-A to USB-C cable to plug
the battery to a power source. This convenient cable enables you to charge your
battery from:
o a wall socket, through an AC adapter (not included in the box, except for
ANAFI Work);
o a tabletop or laptop computer’s USB-A port;
o a power bank’s USB-A port.
Indicative full charging times depending on power sources are as follows (at 20°C):
- AC adapter (5V - 3A): between 150 and 210 minutes;
- a computer’s or power bank’s USB-A port: between 270 and 320 minutes.
ANAFI’s smart battery can also be recharged through a Power Delivery adapter or charger
(USB-PD standard), using a USB-C to USB-C cable (not included in the box). In that
configuration, full charging time of the battery can be reduced to 105 minutes.
About USB-PD power banks: Parrot does not recommend ANAFI users to invest in a
USB-PD power bank, as not all of them support USB-C to USB-C charging of ANAFI’s
battery. Indeed, due to the nature of the USB-C technology, some USB-PD power
banks recharge on ANAFI’s smart battery, rather than the other way around.
To Next Page
Loading...
Need help?
General
