54
16. Check the screen filter on the rubber pad of the oil pump. If there is fuel colloid or other
residues, please clean them.
17. Mount the float and invert the electric fuel pump body, and measure the float height.
Note:
When measuring the height of the float, the float should be placed on the needle valve. Do
not pressurize the float.
Float height:
67.5 mm
18. Install the electric fuel pump assembly in reverse order of removing it.
19. Connect the fuel line, the cooling water line and the power connection line according to the
previous marks.
Engine
Matters needing attention
In order to avoid accidental start during engine maintenance, please take adequate
protective measures to disconnect the ignition system. For example, remove the engine stop safety
line from the emergency stop switch assembly, remove the spark plug cap from the spark plug.
To Next Page
Loading...
