Installing Drivers for 6000 Boards
Line mode is default.
Dot mode is not to draw line between dot and next dot.
[F3] - frame, show / hide the frame
[F4] - dock, show / dock the status bar at bottom of screen
[F5] - pen color
There are 16 colors of pen color:
rainbow, blue, green, cyan, red, magenta, brown, lightgray,
darkgray, lightblue, lightgreen, lightcyan, lightred, lightmagenta,
yellow and white.
[F6] - highlight, highlight the dot in the line mode.
[F9] - camera, you can get the snapshot, and store it in bitmap file.
The filename is 'PM<HHMMSS>.BMP', <HHMMSS> is hour, minute and
second. The resolution of bitmap file is the same as video mode, and the
color depth is 4 bits. (16colors)
Status bar:
640x480 - screen resolution (320x200, 640x480....etc)
S: - number of dots were received per second.
Pen - pen color
P: - the counter of received dots
D: - the counter of pen down
U: - the counter of pen up
(x,y) - current coordinate of dot
x:y: - minimum value of coordinate
X:Y: - maximum value of coordinate
3. Calibrate
Run the 'Calibrate' in PM2 Panel, and choose one of the 25 video modes.
The purpose of calibration is to adjust the touchscreen mapping to
properly meet the display screen.
You will be asked to select a video mode number. Select your display
mode by using keyboard to start calibration.
Touch the upper point, then touch the right point, bottom point and left
point, and press <Enter> key to pass the point. After calibration, the
calibrated data will be showed in the screen.
After calibration, we recommend you to do drawing test to verify the
touchscreen and monitor mapped properly.
Function Keys:
[Enter] - pass current point
[F9] - camera, see above.
4. Detect
Detects PenMount automatically. You can press any key to abort the
To Next Page
Loading...
