Chapter 3 Installing Drivers for 6000 Boards
27
squares in sequence with a stylus. To skip, press
‘ESC’.
Command
Calibration
Command call calibration function. Use
command mode call calibration function, this
can uses Standard, 4, 9, 16 or 25 points to
calibrate.
E.g. Please run ms-dos prompt or command
prompt.
c:\Program Files\PenMount Universal
Driver\DMCCtrl.exe -calibration 0 (Standard
Calibration)
DMCCtrl.exe - calibration ($)
0= Standard Calibration
4=Advanced Calibration 4
9=Advanced Calibration 9
16=Advanced Calibration 16
25=Advanced Calibration 25
To calibrate your touchscreen:
1. Please select a device then click “
Configure
”. You can also
double click the device too.
2. Click “
Standard Calibration
” to start standard calibration.
To Next Page
Loading...
