25
EasyTouch Control System User’s Guide
Heat Menu
Use the heat menu settings to specify the set point temperature and select the heat source for the pool and spa
water. The water will begin to heat whenever the heater is manually switched on, (by pressing the Valves (V)
button (on the Outdoor Control Panel) or the “Pool” or “Spa” button on the Indoor Control Panel), even if the
heater is set to off. The spa will also begin to heat when switched on by the optional iS4/iS10/SpaCommand
Spa-Side remote, or EasyTouch wireless remote. The EasyTouch system allows for solar and conventional
heaters. The EasyTouch will use the heating source that is selected. The heat source selections are:
•
OFF - No heating even though pump and other circuits may be operating.
•
HEATER - Gas heater only. Use the Heater button to automatically switch the heater on which
controls the output between a “forced off” state and a normal, automatic thermostatic control
operating state. The heater will continue heating the water until the heater’s current highest set point
temperature triggers the heater sensor (approximately 104° F (40° C). Note that the Heater button on
the control panel does not activate the pump. Do not activate the heater without running the pump.
The heater will not run if water flow is not detected.
•
SOLAR ONLY - Solar heating system to be the only heat source. In order to display “Solar Pref.” on
the main screen, you must first enable solar in the “Solar” menu (see page 46).
•
SOLAR PREF. (Solar Preferred) - Solar and gas heating systems are installed, and you want to use
solar heating only when it is most effective. In order to display “Solar Pref.” on the main screen, you
must first enable solar in the “Solar” menu. To set the spa temperature and select the heat source:
Pool Temp/Src
To set the pool temperature and select the heat source:
Right button: Select pool temperature and heater options.
Up/Down button: Set the pool temperature from 40° F to 104° F (4° C - 40° C).
Right or Left button: Move to Heater option.
Up/Down: Set Heater option: Off, Heater, Solar, or Solar Preferred.
Press the Menu button to save the settings and to return to the previous menu or
press the button again to return to the main screen.
Spa Temp/Src
To set the spa temperature and select the heat source:
Right button: Select spa temperature and heater options.
Up/Down button: Set the spa temperature from 40° F to 104° F (4° C - 40° C).
Right or Left button: Move to Heater option.
Up/Down: Set Heater option: Off, Heater, Solar, or Solar Preferred.
Press the Menu button to save the settings and to return to the Heat menu or press
the button again to return to the main screen.
SPA
Temp: 85° F
Heat: Off
T
S
POOL
Temp: 72° F
Heat: Off
T
S
POOL Temp/Src
SPA Temp/Src
T
S
X
POOL Temp/Src
SPA Temp/Src
X
T
S
Getting There
MENU HEAT
▲
Note: For an EasyTouch single body system, “Pool” and “Spa” modes are Lo- Temp (Pool) and
Hi-Temp (Spa) temperature controls. For more information, see “Hi-Temp/Lo-Temp Controls for Single
Body Systems,” on page 41.
To Next Page
Loading...
Need help?
General
