37
EasyTouch Control System User’s Guide
Settings Menu: IntelliChlor
While the EasyTouch system is in normal operating mode (“Pool,” “Spa” mode or “Spa Fill (Spillway),” it will
control the IntelliChlor chlorine output level. The amount of chlorine introduced into the pool is determined by
the amount of salt in the water, water temperature, and the amount of time the pool pump is running in “Pool”
mode. Note: While in “Freeze Protection” mode, IntelliChlor will not operate or produce chlorine during the
time that the filter pump is operating. For more information, refer to the IntelliChlor Electronic Chlorine
Generator User’s Guide (P/N 520589).
IntelliChlor
To setup the IntelliChlor:
Right button: Enable/Disable IntelliChlor. (To select SuperChlor, run hours, press the
Up/Down button - 2/2).
Up/Down buttons: Select Ye s or No to enable or disable IntelliChlor.
Right button: POOL Mode “50%” setting.
Up/Down buttons: Set the chlorination output level for the pool water from 0 to
100%. EasyTouch will determine the chlorinator output level when the system is
operating in “Spa” or “Pool” mode. The amount of chlorine introduced into the pool/
sap is determined by the amount of salt in the water, water temperature, and the
amount of time the pool/spa operates in these modes mode.
Right button: SPA Mode “0%” setting.
Up/Down buttons: Set the chlorination output level for the spa water from 0 to 20%.
To prevent over chlorination of the spa, the EasyTouch system will automatically drop
the chlorine output levels to 1/20th of the current pool output when the spa is switched
on. For example, if the pool output level is set to 60%, when the spa is switched on,
the chlorination level is reduced to 3%.
Right button: Move to the next set of settings (2/2).
Up/Down buttons: Select 2/2.
Right button: Move the Super Chlorination settings.
Up/Down buttons: Set Super Chlorination On or Off. See note below about Super
Chlorination.
Right button: Move to “Run Hours” setting.
Up/Down buttons: Set the number of hours to run Super Chlorination. 24 hours is
the default setting. Run hours can be set from 0 to 72 hours.
Press the Menu button to save the settings and to return to the Settings menu
options. Press the button again to return to the main menu options or press again to
return to the main screen.
Note: For IntelliChlor status messages, see “Diagnostics: Chlorinator” page 57.
About Super Chlorination: The Super Chlorination feature is used to introduce large amounts of chlorine into
the pool water if there has been heavy rain fall, many bathers in the pool, cloudy water conditions, etc. When
Super Chlorination is enabled, the system will switch on the filter pump, set the pool/spa valves to the correct
position, and set the IntelliChlor chlorine generator to maximum output. This process continues for 24 hours. At
the end of the Super Chlorination process, the pool will return to normal operation. It is possible to manually
stop the Super Chlorination process and switch off the filter pump using the Filter (F) button on the main control
panel at the pool equipment pad. When the filter pump is switched on again using the Filter (F) button, the Super
Chlorine process will resume for the duration of time left.
IntelliChlor 1/2
Enable: No
Level: 50%
T
S
IntelliChlor 2/2
Super Chlr: Off
Run Hours: 24
S
T
MENU ▼ SETTINGS ▼ INTELLICHLOR
Getting There
To Next Page
Loading...
Need help?
General
