Installer Manual 255/LOGIX 742-762-764 - Programming
44 / 92 Ref. MKT-IM-021 / A - 20.02.2019
11. "g/L"
Indicates that the value entered/displayed for salt amount is in grams/
Liter of resin.
12. "KG"
Indicates that the value entered/displayed is in kilograms or kilograins.
13. "x100"
x100 multiplier for large values.
14. "Lbs/ft
3
"
Indicates that the value entered/displayed for salt amount is in pounds
per cubic foot.
15. Faucet
Appears when the current flow rate is displayed.
The controller may show the faucet and "0", indicating no flow.
16. Maintenance interval
Displayed when the months in service exceed the value programmed in
parameter P11.
17. Digits
Four digits used to display the time, flow rate, volume capacity,
program value or error codes.
18. Number
Used with #19, #20 and #21.
Displays a sequence numbers or values.
19. History values (H)
The number displayed by #18 identifies which history value is currently
displayed.
20. Parameter (P)
Displayed only in advanced programming.
The number displayed by #18 identifies which parameter is currently
displayed.
21. Cycle (C)
The number displayed by #18 is the current cycle in the regeneration
sequence.
22. Hardness
Hardness setting - only used with 760, 762 and 764 controllers for 8-
cycles softening system.
23. Capacity
Shows estimated system capacity.
24. "x2"
Indicates a second regeneration has been called for.
25. Regeneration sign
Flashes when a regeneration at the next time of regeneration has been
called for.
Also displayed (continuously) when in regeneration.
26. Salt
Salt amount for each regeneration setting.
If the controller is on a 3-cycles filter then the backwash time is
displayed.
27. Regeneration time
Time of regeneration and days of regeneration setting.
Days of regeneration setting is only available on 742 controller.
28. Time and day
Current time and day setting.
To Next Page
Loading...
Need help?
General
