Pentax Optio 33LF - Setting the Light Metering Range

48
Taking Pictures
4
You can select which part of the screen to use to measure the
brightness and determine the exposure.
1 Select [AE Metering] on the [A Rec. Mode] menu.
2 Use the four-way controller (45)
to change the setting.
3 Press the OK button.
The camera is ready to take the picture.
A B F D
Setting the Light Metering Range
L
Multi-segment The exposure is determined by the entire screen.
M
Center-weighted
The exposure is determined mainly by the center of the
screen.
N
Spot
The exposure is determined by the small area in the
center of the screen only.
Saving the AE Metering 1 p.68
MENU OK
Recorded Pixels
Quality Level
White Balance
Focusing Area
AE Metering
Auto
1536
2048
AWB
Wide
Exit OK
Rec. Mode
Sensitivity
1
3
2
MENU OK
15362048Recorded Pixels
Quality Level
White Balance
Focusing Area
AE Metering
Wide
Exit OK
Rec. Mode
Sensitivity Auto
AWB