Pentax Q7 - Setting the Drive Mode

3
Shooting
38
4 Turn the focus ring.
The image on the monitor is
magnified.
Available operations
tMemo
• When [Focus Peaking] is set to [On] in the control panel or
[AF/MF Settings] of the A1 menu, the outline of the subject
in focus is emphasized and makes it easier to check the
focus. This function works in both v and w modes.
You can choose from the following drive modes.
V Magnifies the image (x2, x4, or x6).
ABCD Changes the area to display.
Press M to change the display area to
the center.
E Returns to the original size.
x2x2
Setting the Drive Mode
Z
L
Single Frame
Shooting
Normal capture mode
M
Continuous
Shooting (Hi)
Pictures are taken continuously while the
shutter release button is kept pressed.
You can capture up to approx. 5 frames at once.
Not available when [File Format] is set to
[RAW] or [RAW+].
N
Continuous
Shooting (Lo)
You can capture up to approx. 100 frames at
once.
O
Self-timer
(12 sec.)
The shutter is released about 12 seconds after
the shutter release button is pressed.
P
Self-timer
(2 sec.)
The shutter is released about 2 seconds after
the shutter release button is pressed.
Q Remote Control
The shutter is released immediately after the
shutter release button on the remote control
unit is pressed.
R
Remote Control
(3 sec. delay)
The shutter is released about 3 seconds after
the shutter release button on the remote
control unit is pressed.
S
Remote
Continuous
Shooting
Continuous shooting starts when the shutter
release button on the remote control unit is
pressed. Continuous shooting ends when the
shutter release button is pressed again.
T
Exposure
Bracketing
Takes three consecutive images at three
different exposure levels.
Three images are saved with each release in
the order of standard exposure,
underexposure and overexposure.
U
Exposure
Bracket+
Remote Ctrl
Enables Exposure Bracketing shooting with
remote control.
V Multi-exposure
Creates a picture by taking multiple exposures
and merging them into a single image.