Pentax Q7 - Focusing

3
Shooting
34
tMemo
• Sets the adjustment steps for ISO sensitivity in [2. Sensitivity
Steps] of the E1 menu (default setting: 1 EV Step).
• Captured images may show more noise if a higher sensitivity
is set. You can reduce image noise by using [High-ISO NR]
of the A2 menu.
Choose the part of the sensor to use for measuring brightness
and determining exposure.
Set in the control panel or [AE Metering] of the A1 menu.
1 Press C in standby mode.
2 Use CD to select an item.
Auto
Applies Noise Reduction at optimally
calculated levels throughout ISO range.
(Default setting)
Low/
High
Applies Noise Reduction at constant chosen
level throughout ISO range.
AE Metering
v/A1
A
Multi-
segment
The sensor meters the brightness in multiple
different zones. (Default setting)
In backlit locations, this mode automatically
adjusts exposure.
In [4. Link AE and AF Point] of the E1 menu,
you can link the exposure and AF point in the
focusing area.
B
Center-
weighted
Metering is weighted at the center of the
sensor.
The sensitivity increases at the center and no
automatic adjustment is performed even
during backlit scenes.
C Spot
The brightness is measured only within a
limited area at the center of the sensor.
Useful when the subject is small.
Using the Built-in Flash Y
A
Auto Flash
Discharge
Automatically measures the ambient light
and determines whether to use the flash.
B
Auto Flash
+Red-eye
Reduction
Discharges a pre-flash for red-eye
reduction before an automatic flash.
C
Flash On Discharges a flash for each picture.
D
Flash On
+Red-eye
Reduction
Discharges a pre-flash for red-eye
reduction before the main flash.
E
Slow-
speed
Sync
Sets to a slow shutter speed.
Use this when shooting a portrait with
the sunset in the background.
F
Slow-speed
Sync+Red-
eye
Discharges a pre-flash for red-eye
reduction before the main flash is
discharged with Slow-speed Sync.
H
G
Trailing
Curtain
Sync
Discharges a flash immediately before
closing the shutter.
Sets to a slow shutter speed.
Captures moving objects as if they are
leaving a light trail behind them.
J
Flash Off The flash is deactivated.
Auto F lash D ischarg e
Auto Flash Discharge
Cancel
Cancel
OK
OK
OK
MENU
0.0
0.0