PePLink Balance Series v4.0 User Manual
To enable Drop-in mode, perform the following steps from:
Network > Interfaces > LAN:
1. Check the Enable box under Drop-in Mode. (After checking the Enable box, most
network settings for WAN1 will be hidden from Web Administration Interface.)
2. Put the IP address of the WAN1 router in the Default Gateway field. Ensure that the
PePLink Balance IP subnet is the same as the Firewall’s WAN port and the Router’s LAN
port.
3. If hosts other than the router exist on the WAN segment of PePLink Balance, check the
I have other host(s) on WAN segment box, enter the IP address(es) of the host(s),
and then click the down-arrow to add the hosts.
The following diagram illustrates:
To Next Page
Loading...
