peplink Balance 30 - 16.4 Email Notification

PePLink Balance Series v4.0 User Manual
Page 84
16.4 Email Notification
The Email Notification functionality of PePLink Balance provides a System Administrator with
up-to-date information on network status.
The settings for configuring Email Notification are found at the following location:
Network > Misc. Settings > Email Notification:
Email Notification Settings
Email
Notification
This setting specifies whether or not to enable Email Notification.
If Email Notification is set to enable, PePLink Balance sends email
messages to a System Administrator when the WAN status changes, or
when new firmware is available.
If disable is set, PePLink Balance does not send email messages.
SMTP Server
This setting specifies the SMTP server to be used for sending email. If
the Server requires authentication, check the “Require authentication”
check box.
SMTP User
Name /
Password
This setting specifies the SMTP username and password while sending
email. These options are shown only if the “Require authentication”
check box is checked in SMTP Server setting.
Sender’s Email
Address
This setting specifies the sender email address reported by the email
messages sent by PePLink Balance.
Recipient’s Email
Address
This setting specifies the email address to which PePLink Balance
should send the email messages.