peplink Balance 30 - 10.2 Static IP Connection

PePLink Balance Series v4.0 User Manual
Page 33
10.2 Static IP Connection
The Static IP connection method is suitable if the ISP provides a static IP address to connect
directly.
Connection Settings for Static IP
Routing Mode
This field illustrates that NAT (Network Address Translation) will be
applied to the traffic routing over this WAN connection.
For further details, please refer to Appendix B, Routing under DHCP,
Static IP, and PPPoE.
Connection Type
This setting specifies the utilization of the WAN connection.
The selection of Always-on results in the WAN connection to be used
whenever it is available. If Backup Priority and a priority group is
selected, the WAN connection is treated as a backup connection and is
used only in the absence of available Always-on WAN connection(s)
and higher priority backup connection(s).
The default and recommended Connection Type is Always-on.