PePLink Balance Series v4.0 User Manual
12.2 Fine Tuning Load Distribution for Individual Services
By selecting the Outbound Traffic Management of Custom Outbound Traffic Rules from
the drop-down menu and pressing the “Save” button, the following table is then displayed.
The bottom most rule is “Default”. Click on it to change the device’s default way to control
outbound traffic for all connections that does not match any rules above. Click the service
“Default” to change its setting.
By default, the Default Rule “Auto” is chosen. You can change a custom algorithm to be
used. Please refer to the coming chapters for the details of the available algorithms.
To create a custom outbound traffic rule, click Add Rule at the bottom of the table, upon
which the following screen is displayed:
To Next Page
Loading...
