PePLink Balance Series v4.0 User Manual
10.3 PPPoE Connection
The PPPoE connection method is suitable if the ISP provides a PPPoE account and password
to connect via PPPoE.
Network Settings for PPPoE
This setting selects between routing via NAT and IP Forwarding.
By default, Routing Mode is set to NAT.
For further details, please refer to Appendix B, Routing under DHCP,
Static IP, and PPPoE.
This setting specifies the utilization of the WAN connection.
The selection of Always-on results in the WAN connection to be used
whenever it is available. If Backup Priority and a priority group is
selected, the WAN connection is treated as a backup connection and is
used only in the absence of available Always-on WAN connection(s)
and higher priority backup connection(s).
The default and recommended Connection Type is Always-on.
This setting specifies the data bandwidth in the outbound direction
from the LAN through the WAN interface.
To Next Page
Loading...
