peplink Balance 30 - Appendix A. Restoration of Factory Defaults

PePLink Balance Series v4.0 User Manual
Page 97
Appendix A. Restoration of Factory Defaults
To restore the factory default settings on a PePLink Balance unit, perform the following:
For Balance 30/200/300:
1. Locate the reset button at the back of the PePLink Balance unit.
2. With a paper clip, press and keep the reset button pressed for at least 10 seconds,
until the unit reboots itself.
For Balance 380/700:
 Use the buttons to control the LCD menu to go to “Maintenance”  “Factory Default”.
Then choose “Yes” to confirm.
Afterwards, the factory default settings will be restored.
Important Note
All user settings will be lost after restoring the factory default settings.
Regular backup of configuration parameters are strongly recommended.