peplink Balance 30 - 16.8 Saving and Loading Configurations; 16.8.1 Restore Configuration to Factory Settings; 16.8.2 Downloading Active Configurations; 16.8.3 Uploading Configurations

PePLink Balance Series v4.0 User Manual
Page 89
16.8 Saving and Loading Configurations
Backing up the PePLink Balance settings immediately after the successful completion of the
initial setup is strongly recommended.
The functionality to download and upload PePLink Balance settings is found at the following
location: System > Configuration:
16.8.1 Restore Configuration to Factory Settings
The Restore Factory Settings button is to reset the configuration to the factory default
settings. You have to click the Apply Changes button to make the settings effective.
16.8.2 Downloading Active Configurations
The Download button is to backup the current active settings. Click Download and save
the configuration file.
16.8.3 Uploading Configurations
To restore or change settings based on a configuration file, click Browse to locate the
configuration file on the local computer, and then click Upload.
The new settings can then be applied by clicking the Apply Changes button on the page
header, or discard at the Main page of Web Administration Interface.
16.8.4 Uploading Configuration from High Availability Pair
(This section applies only to PePLink Balance 200, 300, 380 and 700.)
In a High Availability (HA) configuration, to quickly load onto the PePLink Balance unit the
configuration of its HA counterpart, click the Upload button.
After loading the settings, configure the LAN IP address of the PePLink Balance unit to be
different from the HA counterpart.