peplink Balance 30 - Page 53

PePLink Balance Series v4.0 User Manual
Page 53
Load Distribution Settings
Service Name
This setting specifies the name of the outbound traffic rule.
Enable
This setting specifies whether the outbound traffic rule takes effect.
With an Enable value of Yes, the rule takes effect: traffic is matched,
and actions are taken, by PePLink Balance based on the other
parameters of the rule.
With an Enable value of No, the rule does not take effect: PePLink
Balance disregards the other parameters of the rule.
Source
This setting specifies the source IP Address, IP Network or MAC
Address for the traffic to be matched for the rule.
Destination
This setting specifies the destination IP Address or IP Network for the
traffic to be matched for this rule.
Protocol and
Port
This setting specifies the IP Protocol and Port of the traffic to be
matched for this rule. You can select some common protocol from the
Protocol Selection Tool drop-down menu.
Algorithm
This setting specifies the behavior of PePLink Balance for the outbound
traffic rule.
One of the following valid values can be specified:
 Weighted Balance
 Persistence
 Enforced
 Priority
The next chapters present the details of the above Algorithms