peplink Balance 30 - Page 59

PePLink Balance Series v4.0 User Manual
Page 59
Services Settings
Enable
This setting specifies whether the Inbound Service takes effect.
With an Enable value of Yes, the inbound service takes effect: traffic
is matched, and actions are taken, by PePLink Balance based on the
other parameters of the rule.
With an Enable value of No, the inbound service does not take effect:
PePLink Balance disregards the other parameters of the rule.
Service Name
This setting identifies the service to the System Administrator.
Valid values for this setting consist only of alphanumeric and the
underscore “_” characters.
IP Protocol
The IP Protocol setting, along with the Port setting, specify the
protocol of the service as one of the following valid values:
 TCP
 UDP
 ICMP
 IP
Traffic that is received by PePLink Balance via the specified protocol at
the specified port(s) is forwarded to the LAN hosts specified by the
Servers setting.
(Please refer below for details on the Port and Servers settings.)
Alternatively, the Common Services drop-down menu can be used to
automatically fill in the Protocol and a single Port number of common
Internet services (e.g. HTTP, HTTPS, etc.)
After selecting an item from the Common Services drop-down menu,
the Protocol and Port number remains manually modifiable.