peplink Balance 30 - Page 76

PePLink Balance Series v4.0 User Manual
Page 76
Outbound
Mappings
This setting specifies the IP address of each WAN connection to be
used for any outgoing traffic originating from the LAN Host.
Note 1: If you do not want to use a specific WAN for outgoing
accesses, you should still choose “default” here, then customize the
outbound access rule in the “Outbound Traffic Management” section.
Note 2: WAN connections in drop-in or IP forwarding mode are not
shown here.
Click Save to save the settings when configuration is complete.
Important Note
Inbound firewall rules override Inbound Mapping settings.