peplink Balance 30 - Page 86

PePLink Balance Series v4.0 User Manual
Page 86
SNMP Settings
SNMP Server
Name
This setting specifies the SNMP server name.
SNMPv1
This setting specifies that SNMP version 1 is to be enabled.
SNMPv2c
This setting specifies that SNMP version 2 is to be enabled.
SNMPv3
This setting specifies that SNMP version 3 is to be enabled.
To add a community for either SNMPv1 or SNMPv2c, click the Add SNMP Community
button in the Community Name table, upon which the following screen is displayed:
SNMP Community Settings
Community
Name
This setting specifies the SNMP Community Name.
Allowed Source
Subnet Address
This setting specifies a subnet from which access to the SNMP server is
allowed.
Enter subnet address here (e.g. 192.168.1.0).
Source Subnet
Mask
This setting specifies the subnet mask that corresponds to the subnet
specified via Allowed Source Subnet Address (e.g. 255.255.255.0).
To define a user name for SNMPv3, click Add SNMP User in the SNMPv3 User Name
table, upon which the following screen is displayed: