Illustration 12 g07674434
Typical example of bank B
Illustration 13 g00955999
Typical example
Label (2) will be installed on coolant pipe next to the
engine oil cooler. Refer to this Operation and
Maintenance Manual, Fluid Recommendations
(General Coolant Information) for information.
i09915008
General Hazard Information
Illustration 14 g00104545
Attach a “Do Not Operate” warning tag or a similar
warning tag to the start switch or to the controls
before the engine is serviced or before the engine is
repaired. Attach the warning tags to the engine and
to each operator control station. When appropriate,
disconnect the starting controls.
Do not allow unauthorized personnel on the engine,
or around the engine when the engine is being
serviced.
• Tampering with the engine installation or
tampering with the OEM supplied wiring can be
dangerous. Personal injury, death and/or engine
damage could result.
• Vent the engine exhaust to the outside when the
engine is operated in an enclosed area.
• Wear a hard hat, protective glasses, and other
protective equipment, as required.
• When working around an engine, the engine must
not be in operation. You may only be near a
running engine to carry out maintenance
procedures that require the engine to be in
operation.
• Do not wear loose clothing or jewelry that can
snag on controls or on other parts of the engine.
• Ensure that all protective guards and all covers
are secured in place on the engine.
• Never put maintenance fluids into glass
containers. Glass containers can break.
• Use all cleaning solutions with care.
• Report all necessary repairs.
12 M0163009
Safety Section
General Hazard Information
To Next Page
Loading...
