i07213693
Alternator Pulley - Check
1. Isolate the electrical supply to the engine. Remove
guard cover from alternator. Refer to Operation
and Maintenance Manual, Belts- Inspect/Adjust/
Replace (Alternator Belt) for removal of the cover
guards.
Illustration 43 g06254152
Typical example
2. Check the torque of the lock screws (2) on the
alternator pulley (1). Also, Check to torque of the
lock screws (4) on the drive pulley (3).
3. The lock screw torque is 20 N·m (177 lb in).
4. Install guard cover to alternator, refer to Operation
and Maintenance Manual, Belts- Inspect/Adjust/
Replace (Alternator Belt) for more information.
5. Connect power supply.
i09652189
Battery - Replace
Batteries give off combustible gases which can
explode. A spark can cause the combustible
gases to ignite. This can result in severe personal
injury or death.
Ensure proper ventilation for batteries that are in
an enclosure. Follow the proper procedures in or-
der to help prevent electrical arcs and/or sparks
near batteries. Do not smoke when batteries are
serviced.
The battery cables or the batteries should not be
removed with the battery cover in place. The bat-
tery cover should be removed before any servic-
ing is attempted.
Removing the battery cables or the batteries with
the cover in place may cause a battery explosion
resulting in personal injury.
1. Check the condition of the battery with a suitable
battery tester.
2. Switch the engine to the OFF position. Remove all
electrical loads.
3. Turn off any battery chargers. Disconnect any
battery chargers.
4. The NEGATIVE “-” cable connects the NEGATIVE
“-” battery terminal to the NEGATIVE “-” terminal
on the starting motor. Disconnect the cable from
the NEGATIVE “-” battery terminal.
5. The POSITIVE “+” cable connects the POSITIVE
“+” battery terminal to the POSITIVE “+” terminal
on the starting motor. Disconnect the cable from
the POSITIVE “+” battery terminal.
Note: Always recycle a battery. Never discard a
battery. Dispose of used batteries to an appropriate
recycling facility.
6. Remove the used battery.
7. Install the new battery.
Note: Before the cables are connected, ensure that
the engine start switch is OFF.
8. Connect the cable from the starting motor to the
POSITIVE “+” battery terminal.
60 M0163009
Maintenance Section
Alternator Pulley - Check
To Next Page
Loading...
