EasyManua.ls Logo

Perkins 5012C-E46TA - Fuel System Primary Filter;Water Separator - Drain; Fuel System Secondary Filter - Replace

Perkins 5012C-E46TA
106 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10. Install new O ring seal (5) to the WIF sensor.
11. Install the WIF sensor.
12. If necessary, connect the WIF sensor to harness
assembly (3) and install new cable strap (4).
13. When the primary fuel filters have been replaced,
the secondary fuel filters must be replaced. Refer
to “Operation and Maintenance Manual”
Secondary Fuel Filter- Replace for more
information.
i09996086
Fuel System Primary Filter/
Water Separator - Drain
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
NOTICE
Ensure that the engine is stopped before any servic-
ing or repair is performed.
1. Place a suitable container under the fuel filters (1)
to catch any fuel that might spill. Clean up any
spilled fuel.
Illustration 98 g07698238
Typical example
2. Install a suitable tube onto the drain (2). Open the
drain (2). Allow the fluid to drain into the container.
3. When only fuel free of water is draining, tighten the
drain (2) by hand pressure only. Remove the tube
and dispose of the drained fluid in accordance with
local regulations and mandates.
i09996101
Fuel System Secondary Filter -
Replace
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
NOTICE
Ensure that the engine is stopped and the battery is
isolated, before any servicing or repair is performed.
A fuel temperature sensor and two fuel pressure
sensors are mounted in the fuel filter base. The
Engine Control Module (ECM) uses the sensors to
monitor the temperature and pressure of the fuel that
is entering the engine.
The electronic service tool (EST) can be used to
monitor the fuel pressure. Contact Perkins distributor
for more information.
88 M0163009
Maintenance Section
Fuel System Primary Filter/Water Separator - Drain

Table of Contents

Related product manuals