CAB AND FRAME ACCESS
1
Batteries
The key
fob uses one CR2032,
3V battery. Batteries should last
approximately three years, depending
on use. Consistently reduced range
is an indicator that the battery needs
replacement. Batteries are available
at most discount, hardware, and drug
stores.
The battery
can be accessed by
removing the cover of the key fob.
After a new battery is installed, the
key fob must be synchronized with the
vehicle.
Synchronization
The key
fob may need to be
synchronized to the truck when the
battery is replaced or when the key fob
has not been used for an extended
period of time.
To
Synchronize A Key Fob:
1. Hold the
key fob near the receiver
which is located behind the
speedometer and tachometer.
2. Press and
hold both the Lock and
Unlock buttons at the same time
for approximately 7 seconds.
3. When the
key fob is
resynchronized, the doors
will lock then immediately unlock.
4. If the
fob fails to synchronize,
it could be programmed to a
different truck or could have failed.
Contact your dealer to re-program
your key fob.
Climbing onto the Deck
Plate
WARNING!
WARNING!
When you are climbing onto and off
the deck plate, maintain at least three
points of contact with your hands on
the grab handles and your feet on the
steps. Always face toward the vehicle
when entering or exiting the cab and
look where you are going. Failure to
comply may result in death or personal
injury.
When stepping onto a surface to enter
the cab or access the deck plate, only
use the steps and grab handles in
-
stalled and designed for that purpose.
Failure to use the proper steps and
grabhandles could cause a fall which
may result in death or personal injury.
(04/13) Y53-6047–2C 1-13
To Next Page
Loading...
