STEERING SYSTEM
take your truck to an authorized Fluid Level and Rell
dealer for evaluation.
Have the
power steering uid and
lters changed
at an authorized dealer.
CAUTION
When adding uid, be sure to use uid
of the same type. While many u
-
ids have the same description and in-
tended purpose, they should not be
mixed due to incompatible additives.
Mixing incompatible uids may lead to
equipment damage.
• Check and completely change the
uid level
according to Preventive
Maintenance Schedule
on page
5-12. Use
the following procedure:
NOTE
Before removing
reservoir cover, wipe
outside of cover so that no dirt can fall
into the reservoir.
• Maximum/Minimum level is
indicated on the reservoir. These
same levels are also indicated by
two lines on the dipstick in the
reservoir.
• There are two ways to check
whether the power steering uid
is at its proper level. Both checks
are with the engine NOT running.
1. If you
check the uid with the
engine and steering system
COLD, the uid level should be
at/or above the Minimum indicator
level and should generally not
exceed the middle point between
Maximum and Minimum level
indicators.
2. If you
check the uid with the
engine and steering system
WARM, the uid should NOT
exceed the Maximum level
indicator and should generally
not drop below the middle point
5
(04/13) Y53-6047–2C 5-131