ELECTRICAL
Follow the procedure below to reinstall
batteries on the vehicle:
Follow the
procedure below to reinstall
batteries on the vehicle:
1. Place batteries
in vehicle and
tighten bolt of holding plate.
2. Reconnect positive
cable.
3. Reconnect ground
(negative)
ground cable.
WARNING!
Battery replacement may alter or dis-
turb battery cable routing. Check to in-
sure battery cables are free from any
point of chafng. Failure to comply
may result in death, personal injury,
equipment or property damage.
Replacing Parts Removed for
Access
1. Replace battery
cover.
2. Install 2
bolts in step strut. Torque
to 24-32 lb-ft (33-43 Nm).
3. Install fairing
and install 4 bolts.
Torque to 6-7 lb-ft (8-9 Nm).
4. Install steps
by installing 2 bolts in
each step. Torque to 24-32 lb-ft
(33-43 Nm).
WARNING!
Always reinstall the steps before en-
tering the cab. Without the steps you
could slip and fall, resulting in possible
injury to yourself.
WARNING!
Fairings not installed properly could
come loose and cause other motorists
to have an injury accident. It is impor
-
tant that fairings be installed properly.
Failure to comply may result in death,
personal injury, equipment or property
damage.
Before attempting any work on the bat-
teries or electrical system, remove all
jewelry. If metal jewelry or other metal
comes in contact with electrical cir
-
cuits, a short circuit may occur causing
you to be injured, as well as electrical
system failure and damage.
WARNING!
5
(04/13) Y53-6047–2C 5-87
To Next Page
Loading...
