Pfaff 421E1 - Page 64

Programming
11 - 27
● Program the fifth (last) seam section:
The seam section should have
- a double end-bartack (1 stitch forwards and reverse),
- stitch counting (5 stitches),
- a stitch length (for roller presser and feed wheel) of 2.5 mm
- and trim the thread at the end of the seam section.
# 5
NO. OF STITCHTS 0
● Select the bartack menu function (number key 8).
● Double click on the double end-bartack function (number key 3).
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 52
2 - SPEED 1500
3 - STITCHES FORWARDS 03
4 - STITCHES REVERSE 03
● Select the STITCHES FORWARDS function.
● Enter the number of stitches.
● Confirm the input by pressing the Enter key.
● Select the STITCHES REVERSE function.
● Enter the number of stitches.
● Confirm this number by pressing the Enter key.
● Finish the inputting of the bartack values by pressing the Enter key.
● Switch on the double end-bartack function (number key 3).
● Confirm the bartack functions by pressing the Enter key.
Enter
Enter
1
3
1
Enter
4
Enter
Fig. 11 - 51
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear