Pfaff 421E1 - Page 71

Programming
11 - 34
Fig. 11 - 63
● Switch on the knee switch function (number key 3).
or:
● Activate the knee switch.
● Confirm the seam section end by pressing the Enter key.
● Input the second seam section:
This seam section should have
- the knee switch function (seam section end)
- and a stitch length of 2.4 mm.
● Select the stitch length function (number key 1).
● Enter the stitch length.
● Confirm with the Enter key.
● Sew the second seam section manually.
The number of stitches is counted and displayed in the status bar.
After stopping, the machine skips automatically to inputting the seam section end.
● Switch on the knee switch function (number key 3).
or:
● Activate the knee switch.
● Confirm the seam section end by pressing the Enter key.
● Input the third seam section:
This seam section should have
- the pedal function (seam section end)
- and the thread trimmer (seam section end)
- and a stitch length of 2.8 mm.
Enter
4
2
Enter
Enter
# 2
NO. OF STICHTES 2
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
# 1
Fig. 11 - 64
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear